How to Reset Your Macard WiFi Extender
Performing a reset on your Macard WiFi extender will remove all previously configured settings. Once the reset is complete, you'll need to reconnect and reconfigure the extender to restore your desired settings.
To reset the Macard WiFi extender, locate the small "RESET" button on the side panel of the device. Using a pen or paper clip, press and hold the button for about 10 seconds. After resetting, you’ll need to set up the extender again through the Macard WiFi interface.
How to Reconfigure Your WiFi Extender After Reset
Once your extender has been reset, you can reconnect it to your router using either the WPS method or the web-based interface. Here's how to do both:
WPS Method:
- Plug the extender close to the router.
- Power on the extender and press the WPS button on the device.
- Press the WPS button on your WiFi router.
- Wait for the devices to connect, and then join the extended network using the host router's SSID and password.
- The WPS method will configure the extender with the default settings based on the router’s configuration. If you need to make additional adjustments, you can use the web interface for further customization.
Web-Based Interface:
To reconfigure the extender using a computer, follow these steps:
- Ensure your computer is connected to the extender's network. Then, open a browser and go to the URL go.macard.online or the IP address 192.168.10.1.
- The Macard WiFi extender setup page will appear. Enter the default admin password: admin.
- Click the "LOGIN" button to access the interface. Select the host router network and enter its password.
- On the next page, create a new WiFi username and password for the extended network.
- Click the "SAVE" button and wait for the extender to restart and establish a new connection with the router.
- Once this process is complete, you’ll see a new network in your Wi-Fi list, where you can connect using the updated SSID credentials.
Troubleshooting Tips to Avoid Resetting Your Extender
Before resorting to a full reset, you can try the following steps to troubleshoot common issues:
Reboot Your Macard WiFi Extender:
Sometimes, a simple reboot can resolve technical problems. To restart your extender, either press the power button to turn it off and on, or unplug it from the wall socket and plug it back in.
Check the Router and Extender Connection:
Ensure that the extender is properly connected to the router via WPS or the web interface. If the devices aren’t connected, the extender won’t be able to extend the Wi-Fi signal. Check if the extender is within range of the router, and move it closer if necessary.
Reconfigure the Extender Settings:
Rather than resetting the device, try reconfiguring the extender’s settings. Log in to the Macard interface on your computer by visiting go.macard.online or 192.168.10.1. Check the status of the extender’s connection and adjust its settings, including frequency, to suit your home’s layout.
Conclusion
Macard WiFi extenders help amplify your router’s signal throughout your home. However, if the extender stops working properly, resetting it may be necessary. In this article, we’ve provided instructions on how to reset your extender and reconfigure it using various methods. Following these steps should help you restore functionality to your device.